Filter
Top Products
33.18
•
Apply a load of approx. 85 Kg (1887.43 lb)to the
motorcycle and tighten loose strut (4) with the
nut on the wheel side.
X Tightening torques:
Strut to rear wheel drive ............................... 43 Nm
Suspension strut to rear wheel drive ............ 51 Nm
•
Tighten the strap holding the flexible gaiter.
•
Add oil.
Oil content:
Initial filling................................. 0.25 l (0.44 Imp.pt)
First oil change.......................... 0.23 l (0.41 Imp.pt)
Gear oil grade:
Use brand-name hypoid gear oil, SAE 90, API Class
GL 5.
L Note:
Add oil only up to the lower edge of the thread in the
filler aperture.
•
Install the brake disc in the previously marked
position
X Tightening torque:
Brake disc to rear wheel drive...................... 21 Nm
•
Install the rear wheel, insert the wheel studs and
tighten them in the specified order.
X Tightening torques:
wheel studs:
Stage 1 ........................................................ 50 Nm
Stage 2 ...................................................... 105 Nm
•
Install the brake caliper
e Caution:
Do not damage or tilt the brake pads.
•
[ABS] Check sensor grap.
[ABS] Rear sensor grap ............. 0.60 . . . 0.65 mm
.....................................................(0.0236...0.0256
X Anziehdrehmoment:
Brake caliper to rear wheel drive.................. 32 Nm
•
Install number plate holder.
LT330320
1
4
2
5
3