Filter
Top Products
11.29
Removing, dismantling and assem-
bling combined oil-water pump
Removing pump
•
Pull off the wires for the oil pressure and water
temperature display at the switch.
•
Pull the wires out of the housing.
•
Remove housing cover (2) and loosen the gasket
with light blows of a plastic-faced hammer.
•
Remove the housing and loosen the gasket with
light blows of a plastic-faced hammer.
•
Pull off the housing.
Dismantling pump
•
Clamp the pump housing into a vise at the seal-
ing faces, using soft jaws.
•
Remove the impeller (5), holding the pump shaft
to prevent it from moving.
•
Take off the impeller with spacing bushing (6).
•
Pull out pinion (8) and pump shaft (9).
•
Examine the pump housing for damage.
3
4
5
6
8
9
1
2
LT110422