Filter
Top Products
33.20
Removing and installing gaiter
•
Remove inner retaining ring, pull gaiter out of
swinging arm.
•
Install in the reverse order of removal.
•
Coat inside and outside (arrows) of sealing lip
with, for example, Optimoly MP3.
Removing drive shaft
•
Press off drive shaft with screwdriver.
e Caution:
Avoid scratching painted parts;use a rubber under-
lay if necessary.
Checking universal joint for wear
•
Determine axial and radial play by shifting axially
and turning radially.
Removing retaining ring
•
Lever out retaining ring in universal joint using a
small screwdriver.
•
Install in the reverse order of removal.
Installing drive shaft
•
Coat spline of drive shaft with, for example,
Optimoly MP3.
•
Fit drive shaft on output shaft.
•
Engage snap ring in position with light blows
(plastic-headed hammer).
LT330300 LT330380
LT330420