Filter
Top Products
31.11
Disassembling telescopic fork
Removing fixed tube
•
Loosen clamping screws at lower fork bridge.
•
Remove fixed tube with slider tube from fork
bridge.
•
Drain oil.
•
Clamp slider tube at mounting for brake caliper in
vice with jaw guards.
•
Release bottom screw fitting and pull out fixed
tube.
Disassembling slider tube
•
Clamp slider tube at mounting for brake caliper
vertically in vice with jaw guards.
•
Using a blunt knife, lever out dust sleeve (1) from
the outside.
•
Using a small screwdriver, lever out retaining ring
(2) for sealing ring.
•
Fit support ring (3), BMW No. 31 3 610, on slider
tube.
•
Lever out shaft sealing ring (4) using a slightly
rounded off screwdriver.
•
Remove steel ring (5).
•
Using both index fingers, remove plain bush (6)
from slider tube.
•
Check plain bush for damage/wear; replace if
necessary.
31 3 610
LT310110
1
4
2
5
6
4
3
LT310120