12.16
Removing and installing starter
•
Remove control unit.
•
[ABS I] Remove control unit.
•
[ABS II] Drain front and rear brake systems.
•
[ABS II] Remove pressure modulator.
•
Remove battery.
•
[ABS II] Take off battery carrier.
•
Release earth (ground) connection (1) at starter.
•
Release positive lead at starter.
•
Release second retaining screw (3).
•
Pull out starter towards rear.
•
Install in the reverse order of removal.
L Note:
[ABS II] Refill the front and rear brake systems.
X Tightening torques:
Starter to transmission
................................... 9 Nm
Positive lead to starter.................................... 5 Nm
LT120150
2
3
1