
46.11
Removing lever
•
Remove actuator motor.
•
Remove plate.
•
Detach spring.
•
Release securing element (3) of guide rod (4),
while holding with pin (5).
•
Pull guide rod out of sliding bushing, note
O-rings (6).
•
Remove retainer (7) and press out shaft (8).
•
Install in the reverse order of removal.
L Note:
The retaining screws are micro-encapsulated and
therefore cannot be re-used. Clean the threads and
the holes. Coat screws with Loctite 243 before in-
serting.
Spray guide rod with silicone spray.
Removing guide bush in lever
•
Remove lever.
•
Loosen locknut (1), unscrew pressure screw (2).
L Note:
Installation:
Only tighten pressure screw such that the guide
bush can still be moved easily, then lock with hexa-
gon nut.
X Tightening torque:
Locknut.......................................................... 7 Nm
Removing sliding piece
•
Remove actuator motor.
•
Remove plate.
•
Remove lever.
•
Release securing element (3) for sliding piece (4)
on the plate.
•
Remove retaining bracket (5) for tubes.
•
Remove sliding piece completely out of tube.
LT460100
3
4
8
3
5
6
7
LT460110
1
2
LT460120
3
5
4