Filter
Top Products
36.7
Removing and installing rear wheel
Removing rear wheel
•
Remove number plate bracket.
•
Remove the brake caliper.
•
Pull off cap (1) with an angled screwdriver.
•
Unscrew wheel studs (2).
•
Take out the rear wheel.
•
Note the presence of spacing washer (3).
Installing rear wheel
•
The contact faces on the spacing washer, the
rear wheel drive and the wheel hub must be free
from grease and clean.
•
Offer the rear wheel with the spacing washer up
to the rear wheel drive, and screw in all wheel
studs handtight.
e Caution:
Only use wheel studs with length code 60.
LT360040
1
2
2
3
60
•
Tighten the outer wheel studs in a crosswise pat-
tern to the preload torque.
•
Tighten the central stud to the specified torque.
•
Tighten the outer wheel studs in a crosswise pat-
tern to the specified torque.
•
Install brake caliper.
Tightening torque:
Preload torque ............................................. 50 Nm
Wheel studs/central stud ........................... 105 Nm
Brake caliper to rear wheel drive.................. 32 Nm
•
Check ABS sensor gap.
ABS sensor gap, rear
Up to 1996
model year..........0.60…0.65 mm (0.024…0.026 in)
From 1997
model year on .....0.45…0.55 mm (0.018…0.022 in)
•
Install number plate holder.