Filter
Top Products
23.10
Disassembling/assembling transmis-
sion cover
Removing and installing bearing shell
•
Heat bearing cover to 100 °C.
•
Remove bearing shell with Kukko support,
BMWNo.008560, and internal extractor 21/5,
BMWNo.008563.
•
Fit bearing shell in transmission cover while still
hot.
•
Drive bearing shell onto the bottom of its seat
with drift, BMW No. 23 1 700, and handle
BMWNo.005500.
Removing and installing shaft sealing ring on
input shaft
•
Drive out shaft sealing ring with drift from the in-
side.
•
Fit new sealing ring with drift, BMWNo.231770
and handle, BMW No. 00 5 500.
L Note:
If the coefficient of friction of the input shaft is to be
checked, do not fit sealing ring until measurement
has been completed.
Removing and installing locking lever
•
Release retaining ring (1)
•
Lift short arm of spring over contact surface (ar-
row).
•
Remove lever and spring.
•
Install in the reverse order of removal.
LT230020
100°C
00 8 563
00 8 560
00 5 500
LT230030
23 1 770
23 1 770
LT230040
00 5 500
LT230050
1