Filter
Top Products
11.41
Installing combined oil-water pump
•
Apply a thin coat of 3-Bond 1209 to the sealing
faces, which must be free of oil and grease.
•
Place O-ring on water passage.
•
Insert the input pinion into the output shaft with
an oiled O-ring.
•
Attach the pump housing and insert the screws
loosely at first.
L Note:
Turn the crankshaft several times in order to centre
the gearwheels, at the same time gradually tighten-
ing the retaining screws.
•
Tighten the retaining screws fully.
X Tightening torque:
Pump housing to crankcase........................... 7 Nm
•
Insert the wire for the oil pressure telltale and
temperature display through the housing and
connect it.
•
Apply a thin coat of 3-Bond to the sealing faces
on the cover and housing, which must be free
from oil and grease.
•
Place the housing cover in position and tighten it.
X Tightening torque:
Cover to pump housing.................................. 7 Nm