Filter
Top Products
12.5
Removing and installing Hall gener-
ator
•
Disconnect ground lead of battery and insulate.
•
Remove radiator cowling.
•
Remove fuel tank.
•
Disconnect Hall generator (1) plug connection.
•
Remove cover (2) together with gasket (3).
•
Remove base plate (4).
•
Remove rotor (5) and setting plate (6).
L Note:
Mark installation position of setting plate on engine
case, or remove in TDC position.
•
Install in the reverse order of removal.
L Note:
The recess on the engine case and on the base
plate must be aligned flush.
X Tightening torques:
Base plate................................................... 3.5 Nm
Cover ............................................................. 9 Nm
LT120010
6
1
5
4
3
2