Filter
Top Products
11.42
Installing cylinder head
•
Move the piston in cylinder 1 to top dead centre
(cylinder 1 = timing end).
•
Place the cylinder head gasket in position; no
holes or passages must be obstructed.
L Note:
Use only cylinder head bolts with long thread
[from 12/94].
•
Place the cylinder head in position and insert
bolts (1) with washers (2) as far as possible.
•
Tighten the cylinder head bolts in the order
shown.
X Tightening torque:
Cylinder head bolts ..................................... 20 Nm
•
Attach tighten angle measuring device,
BMW No. 11 2 500, using two T 50 Torx inserts,
BMW No. 00 2 630.
•
Tighten the cylinder head bolts, to the specified
torque and angle, as specified.
Tightening angle................................................ 90°
1
2
LT110640
1
2
3
4
5
6
7
8
9
10
LT110660