Filter
Top Products
17.5
Changing coolant
Draining coolant
•
Remove fuel tank.
•
Release cap (1) on filler neck.
•
[RS] Remove lower section of fairing
•
Release screw plug (2) on water pump [RS] , or
water temperature sensor
[LT].
•
Note gasket.
X Tightening torque:
Drain plug, temperature sensor
......................9 Nm
Filling with coolant
•
Fill with coolant up to lower edge of filler neck (1).
Coolant:
Concentration (down to – 28 °C)
Antifreeze
......................................................40 %
Water..............................................................60 %
Capacity.....................................3.0 l (0.66 Imp.gal)
Quantity in expansion tank.......0.4 l (0.088 Imp.gal)
•
Crank engine with starter while kneading hose
between water pump and filler neck
•
Assemble motorcycle.
LT170010
1
3
2
LT170020
1