Filter
Top Products
00.19
Checking increased starting speed
(choke) and adjusting if necessary
Inspections I, III
Checking increased starting speed
•
Remove the left battery cover.
•
Move the increased starting speed device up to
its limit stop (stage 2).
e Caution:
Screw (2) is secured with lacquer and must not be
reset.
L Note:
Stop face (1) must make contact with screw (2) and
the wire cable must have zero play; failing this, cable
play must be adjusted.
•
Check stop face (1).
•
Move the increased starting speed device up to
its limit stop (stage 2).
•
Loosen locknut (3).
•
Press the lever with stop face (1) against screw
(2).
•
Turn adjusting screw (4) to obtain zero play in the
cable.
•
Tighten locknut (3).
LT130030
1
2
3
4