Filter
Top Products
33.17
Installing rear wheel drive
•
Coat spline on sliding piece (arrow), for example
with Optimoly MP3.
•
Fit inner race (5) of right-hand needle bearing
with a little grease, e.g. Optimoly TA.
•
Fit rear wheel drive with gaiter in position, insert
sliding piece in drive shaft.
•
Loosely secure spring strut to rear wheel drive.
e Caution:
The bearing pin of the fixed bearing?(1) is micro-en-
capsulated, clean thread!
•
Screw in bearing pin (1) with Loctite 2701.
e Caution:
The inner bearing race must never press against the
end faces of the needles!
X Tightening torque:
Bearing pin of fixed bearing ....................... 150 Nm
(clean thread + Loctite 2701)
•
Screw in the bearing pin of the loose bearing (3)
with Loctite 2701.
X Tightening torques:
Bearing pin of loose bearing .......................... 7 Nm
(clean thread + Loctite 2701 applied to entire
length of thread on loose bearing pin)
Locknut...................................................... 105 Nm
e Caution:
The final tightening torque must be applied without
delay to threaded connections secured with
Loctite 2701. The Loctite requires at least 3 hours
to harden.
L Note:
To clean use an acetone-based cleaning product,
e.g.
Loctite 706 rapid cleaner
(Loctite order No. 70636-AC).
LT330320
1
4
2
5
3