Filter
Top Products
32.7
Removing and installing right handle-
bar fitting
•
Remove fuel tank.
•
[LT] Cut through cable clip (1).
•
Disconnect plug connection (2) for brake light
switch.
•
Release brake line (3) and close off.
•
Release multifunction switch (4).
•
Loosen cover (5) for accelerator cable.
•
Detach accelerator cable (6).
•
Remove handlebar weight (7).
•
Loosen clamping screw (8) from fitting housing.
•
Remove fitting.
•
Cut through rubber grip and remove.
•
Install in the reverse order of removal.
e Caution:
Top up brake fluid, vent system!
L Note:
Turn connection piece (3) of the brake line such that
the brake line does not chafe at any point when the
handlebar is turned.
X Tightening torques:
Brake line ........................................................7 Nm
Bleed screw.....................................................7 Nm
Clamping screw...............................................5 Nm
Setting:
Accelerator cable play............. 0.75 mm (0.0295 in)
LT320040
3
1
1
4
4
2
1
LT320050
8
7
6
5