Filter
Top Products
00.23
Checking steering bearing play and
adjusting if necessary
Inspection III
•
Place a piece of adhesive tape (arrow) on the fork
bridge above the setting ring (1).
•
Mark current position of setting ring (1) on the
adhesive tape and on the setting ring (2).
•
Slide thrust ring (3), BMW No. 31 4 890, over the
locking tube (4).
•
Lock thrust ring with hexagon nut (5) while hold-
ing the locking tube.
•
Using the hexagon nut, turn back the setting ring
a little then firmly tighten to the specified setting
torque.
Setting torque:
Hexagon nut ............................................... 12 Nm
New bearing:
Pretighten hexagon nut to............................ 25 Nm
Move steering several times from stop to stop,
loosen hexagon nut and retighten................ 12 Nm
•
Mark new position of setting ring on adhesive
tape.
•
Loosen hexagon nut and remove thrust ring.
•
Firmly tighten locking tube, firmly tighten hexa-
gon nut.
L Note:
The position of the setting ring must no longer
change!
•
The position of the setting ring must no longer
change!
•
Firmly tighten clamping screws.
X Tightening torque:
Locking tube................................................ 65 Nm
Hexagon nut ................................................ 65 Nm
Clamping screws of fork bridge (6)............... 15 Nm
Clamping block for handlebar ...................... 22 Nm
LT320110
31 4 890
6
5
4
6
1
3
1
2
LT320120