Filter
Top Products
23.23
Measuring distances between transmission shafts
Example:
•
Remove measuring plate from transmission
housing.
•
Fit calculated spacer shim rings on the input
shaft.
•
Heat taper roller bearing to 80°C and fit on input
shaft.
•
Lightly grease spacer shims for intermediate
shaft and output shaft and fit flush on ball bear-
ing.
Maße in mm (in)
Output shaft
”ab”
Intermediate
shaft
Input shaft
”an”
H 30.00
(1.1811 in)
30.00
(1.1811 in)
30.00
(1.1811 in)
+ M (
measure!) 5.45
(0.2146 in)
6.05
(0.2382 in)
-20.10
(-0.7913 in)
= G 35.45
(1.3957 in)
36.05
(1.4193 in)
9.90
(0.3897 in)
D (
measure!) 36.40
(1.4331 in)
36.90
(1.4528 in)
11.30
(0.4449 in)
- G -35.45
(-1.3957 in)
-36.05
(-1.4193 in)
- 9.90
(-0.3897 in)
= clearance without spacer shim rings 0.95
(0.0374 in)
0.85
(0.0335 in)
1.40
(0.0551 in)
– specified axial clearance - 0.05
(-0.00197 in)
- 0.05
(-0.00197 in)
+ 0.05
(+0.00197 in)
=
thickness of spacer shim ring 0.90
(0.0354 in)
0.80
(0.0315 in)
1.45
(0.0571 in)