Filter
Top Products
11.46
Installing intermediate flange
Installing freewheel
•
Insert the freewheel into the crankcase with the
helical-cut gearwheel leading.
•
Oil the needle roller bearing well.
Installing countershaft
•
Insert countershaft (1) into the crankcase with
the small gearwheel facing downwards.
•
Insert spring (2) with the larger external
diameter (arrow) projecting upwards and located
behind the freewheel gear.
Installing intermediate flange
•
Apply a thin coat of 3-Bond 1209 to the sealing
faces, which must be free from oil and grease.
•
Attach the intermediate flange (with all collets in
position).
•
Tighten screws with Torx insert,
BMWNo.002600.
X Tightening torque:
Intermediate flange......................................... 9 Nm
L Note:
Note rubber filler in the starter motor area.
Installing driver
•
Clean tapped hole and screw (must be free from
grease).
•
Push driver on to layshaft.
•
Secure retaining screw with Loctite 273 FL.
X Tightening torque:
Driver ........................................................... 33 Nm
Installing alternator
•
Install the alternator with the damping rubber.
X Tightening torque:
Alternator..................................................... 22 Nm
1
2
LT110690