Filter
Top Products
46.25
Assembling side stand
L Note:
The securing screw of the side support is micro-en-
capsulated and cannot be reused. Clean thread and
holes. Coat screws with Loctite 243 before insert-
ing.
•
Fit securing screw (6) with Loctite 243.
•
Fit leg spring (1) as illustrated.
•
Install operating hook (2) and bracket (3), note in-
stallation position (arrow).
e Caution:
Do not grease operating hook and bracket,
increased dirt accumulation!
•
Attach tension springs (4).
•
Prior to installation, check condition of switch,
contact spring must not be bent.
•
In no-load condition, there must be an air gap
(clearance) between the contact spring (1) and
contact point on the switch.
•
Secure switch with 2 O-rings (2) on the retaining
screws for the bearing block.
•
Install stand with side stand.
X Tightening torque:
Side stand to bearing block ......................... 41 Nm
LT460350
2
4
3
1
LT460360
2
1