Filter
Top Products
23.25
Installing transmission (gearbox)
•
Clutch thrust bearing must be removed.
•
Check centre position of driving disk.
•
Coat spline of input shaft, for example with
Optimoly MP 3.
•
Screw guide pins, BMW No. 23 1 820, in the
holes with centring sleeve in the intermediate
flange.
•
Screw in long pin on right-hand side.
•
Fit slip sleeve, BMW No. 23 1 800, on control
rod.
•
Fit control rod from front through the input shaft.
•
Place transmission on guide pins (oiled) and
carefully slide into position.
X Tightening torque:
Transmission to intermediate flange
............. 16 Nm
•
Install clutch thrust bearing.
23 1 820
LT230470
23 1 820
LT230530
23 1 800