Filter
Top Products
23.13
Removing selector shaft
•
Release setscrew (arrow) (secured with Loctite).
•
Pull out selector shaft together with gearshift le-
ver.
Removing segment
•
Remove retaining ring (arrow).
•
Remove segment (1) together with coil spring (2)
and limit stop (3).
•
Install in the reverse order of removal.
e Caution:
Secure setscrew with Loctite 242; screw and hole
must be clean and free of grease.
X Tightening torque:
Setscrew, selector shaft
............................... 17 Nm
•
Drive in transmission case bent by 10 mm and fit
cap.
Removing and installing shaft sealing
ring on input shaft
•
Drive out shaft sealing ring from inside.
•
Fit shaft sealing ring using drift,
BMWNo.231760 and handle,
BMWNo.005500.
LT230110
LT230120
1
2
3
23 1 760
LT230130
00 5 500