Filter
Top Products
USER MANUAL
ENGLISH
RS 2200 33019476(3)2010-02 A
33
AFTER USING THE MACHINE
After using the machine, store it as follows:
The hopper must be lowered (see Using The Machine paragraph).1.
The engine must be off (see Diesel Engine Start and Stop paragraph).2.
The lights must be turned off.3.
The parking brake must be engaged.4.
The ignition key must be removed.5.
TRANSPORTING BY TRAILER
To transport the machine, place suitable bands on the machine anchors to fi rmly fasten the machine to the means of transport.
WARNING!
Machine anchorage must be performed by qualifi ed personnel.
Fastening the machine on the trailer bed
To anchor the machine in case of transport by trailer, proceed as follows:
Set the machine to transport mode (see the procedure in the relevant paragraph).1.
Remove the ignition key (6, Fig. D).2.
Engage the parking brake (3, Fig. D).3.
Close all doors, hoods, etc.4.
Fasten the machine to the trailer bed by using suitable bands (1, Fig. B) as shown in Fig. B.5.
Lock the wheels by using the wedges (2, Fig. B).6.
Moving the machine on the trailer bed
To move the machine on the trailer bed, perform the following procedures:
Use a lift truck having a suitable lifting capacity (35/40 quintals).1.
Place the lift truck on the trailer bed marked points.2.
CAUTION!
If the lift truck is placed on different points, the machine can get unbalanced.
MACHINE STORAGE
If the machine is not going to be used for more than 30 days, proceed as follows:
Prepare the machine, as shown in the After Machine Use paragraph.1.
Store the machine indoor, in a clean and dry place, protected from bad weather conditions and with the following values:2.
Temperature: +1 °C to +50 °C•
Humidity: max. 95%•
Disconnect the battery negative connector.3.
Handle the diesel engine as shown in the relevant Manual.4.
FIRST PERIOD OF USE
After the fi rst period of use (fi rst 8 hours) it is necessary to perform the following procedures:
Check the fastening and connecting elements for proper tightening. Check the visible parts for integrity and leaks.1.
Always perform checks and replacements shown in the Scheduled Maintenance Table.2.