Filter
Top Products
USER MANUAL
ENGLISH
RS 2200 33019476(3)2010-02 A
11
Consultation of B_BOX• (7, Fig. J), where all the
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (23, Fig. E) until “MAIN MENU”
appears. Confi rm by pressing the lower part of the
push-button (23, Fig. E). The arrow cursor (1, Fig. J)
will be placed near the word “STATUS”. Press the lower
part of the push-button (23, Fig. E) again to bring the
arrow cursor near the word “MAINTENANCE”. Confi rm
by pressing the upper part of the push-button (23, Fig.
E). On the display (32, Fig. E) the page “MAINT.01”
is shown; when pressing the upper part of the push-
button (23, Fig. E) again, the page “MAINT.02” is
shown. When pressing the lower part of the push-
button (23, Fig. E), the cursor aligns with B_BOX,
then enter the B_BOX by pressing the upper part of
the push-button (23). In this page, the fi rst series of
numbers (33, Fig. J) indicates the alarm identifi cation
number, while the second series of numbers (34)
indicates the time at which the alarm occurred. The
stored alarms are up to 16 displayed on four pages,
which can be scrolled by pressing the push-button
(23, Fig. E) repeatedly. The alarms shown are both
instrument inner alarms and CAN-BUS transmission
line inner alarms indifferently.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
Machine layout description
(See Fig. F)
Fuel tank1.
Right front water tank2.
Right rear water tank3.
Steering cylinder4.
Right rear drive wheel5.
Right front wheel6.
Hopper7.
Right side water tank drain plug8.
Fuel tank fi ller cap9.
Engine air fi lter10.
Drive system pump11.
Turbine pump12.
Accessory pump13.
Battery hygrometer14.
Condenser electric fan15.
Right front water tank lower fastener16.
Right front water tank upper fastener17.
Battery18.
Hydraulic system oil tank drain plug19.
Hand pump lever20.
Compressor21.
Coolant drain hose22.
Dust control system pump fi lter23.
Climate control system condenser24.
Frame number25.
Suction inlet-hopper branch pipe26.
Suction fan assembly27.
Hand pump28.
Radiator fan motor29.
DPF differential Pressure Sensor30.
Vacuum modulators31.