Filter
Top Products
Appendix B: Using the Auxiliary Junction Box B-5
Raystar 114
Combined GPS and
Differential Beacon
Receiver
Raystar 114 Combined GPS and Differential Beacon
Receiver
To connect your Raystar 114 Combined GPS and Differential Beacon
Receiver to your display, cut off the 5-pin connector, strip back the insulation
on all the wires and connect to the Auxiliary Junction Box as shown in the
illustration below.
CAUTION:
Ensure the correct polarity of the 12 V supply before applying display or
SeaTalk power. It is recommended that a multimeter is used to check the
connections.
Note: Youcanuse theGPS Set-Uppage tomanually tune the Raystar114. Re-
fer to Chapter 6 for details.
12V
Power
Supply
(fused)
From
Combined
GPS/DBR
sensor
Green
Red
Black
To Display Unit
SeaTalk Socket
D4301_1
Red
Black
White
Yellow
81186_3.book Page 5 Thursday, August 22, 2002 8:23 AM