Filter
Top Products
2-8 hsb
2
PLUS Series LCD Display
Selecting the Mode of
Operation
➤ To changethe mode, pressthe DISPLAY keytoshowtheDISPLAY pop-up,then
press again to cycle through the modes available, shown in the Figure 2-5.
Figure 2-5: Using the DISPLAY Key
The selected mode is shown by an icon with a red border and the mode is
displayedon the screen. Theassociated half-screenwindow soft keysare also
displayed.
When the required mode is shown, press ENTER or CLEAR. The default soft
keys are displayed. The selected mode is shown full-screen; in Radar and
Chart mode you can switch on half-screen windows for additional display, as
described in the following section.
Ifyou pressDISPLAY again,the pop-up andsoft keys forthe currentmode are
shown.
Selecting a Half-Screen Window for Display
Note: Windows can only be used with Radar or Chart screens, they are not
available on the data log screen.
➤ To select a window for display:
1. From the full-screen Radar or Chart mode, press the DISPLAY key. The
following soft are displayed with an image of each available window:
DISPLAY
81186_3.book Page 8 Thursday, August 22, 2002 8:23 AM