Filter
Top Products
7-2 hsb
2
PLUS Series LCD Display
Changing the Set Up
Parameters
7.2 Changing the Set Up Parameters
The set up parameters are divided into four sections:
• System, to control the aspects of the system that are not specific to the
radar or chart.
• Radar, includes bearing alignment, display preferences and the timed
transmission option.
• MARPA, to controlthe MARPA target tracking parameters,including tar-
get vectors, safe zone and target history display.
• Advanced, to control specialist radar settings such asdisplay timing, STC
preset and tune preset (see Section 7.6 for instructions on how to access
these functions).
• Chart,tocontrolthechartplotterdisplay,includingwaypointinformation,
vectors and radar/chart synchronization.
Note: The GPS and Track Set Up menus are described in Chapter 6.
This section provides instructions for displaying and changing the default
values. The following sections list the parameters and their possible settings,
and describe the function of each parameter in turn.
➤ To set the default parameters:
1. Press the MENU key to display the set up soft keys - the options available
depend on the selected operating mode.
Radar
Chart
2. Press the soft key for the set up you require.
The requested set up menu is displayed, listing the parameters and their
current settings.
3. Usethe trackpad to move the selection bar up and down the list. An arrow
is displayed at the top or bottom right-hand corner if you can scroll the list
to display further parameters.
As each line is highlighted, the soft keys are updated to show the settings
available.
MENU
D3640-3
SYSTEM
SET UP¬
RADAR
SET UP¬
MARPA
SET UP¬
D4162-1
SYSTEM
SET UP¬
CHART
SET UP¬
TRACK
SET UP¬
GPS
SETUP¬
81186_3.book Page 2 Thursday, August 22, 2002 8:23 AM