Raymarine hsb2 PLUS Series GPS Receiver User Manual


 
3-4 hsb
2
PLUS Series LCD Display
Interpreting and
Adjusting the Radar
Picture
3.3 Interpreting and Adjusting the Radar Picture
Navigational echoes may be large, small, bright or faint, depending not only
on the size of the object but also on its orientation and surface. Different
objects reflect the radar signals in different ways. For example, vertical
objects such as cliffs reflect signals better than sloping ones such as
sandbanks.
High coastlines and mountainous coastal regions can be observed at the
longestradarrange.However,thefirstsightof landmaybea mountainseveral
miles inland from the coastline. The actual coastline may not appear on the
radar until the vessel is close to the line of sight distance.
The radar indication may not be similar to your visual observation; a nearby
small object may appear to be the same size as a distant large object on the
radar. However, with experience the approximate size of differentobjects can
be determined by the relative size and brightness of the echoes.
Some targets, such as buoys and small boats, can be difficult to differentiate,
since they bob and toss about in the waves and do not present a consistent
reflecting surface. Consequently, these echoes have a tendency to fade and
brightenand, attimes, todisappear momentarily. Buoysand smallboats often
resemble each other, but boats can usually be distinguished by their motion.
Not all radar echoes are produced by hard navigational items. Some echoes
may be received from irregularities on the surface of the water, particularly at
closerange (seaclutter),or from rain or snow either around the vesselor inthe
distance.Inaddition,some echoesmay beindirectreturnstotheradarscanner,
providing false echoes or multiple echoes.
Theeffectsof manyfalseechoescanbeminimized,andthetargetpresentation
clarified using the controls summarized below. This section explains how to
interpret the radar picture and how the controls affect the display. It provides
instructions for adjusting the settings, describes the circumstances in which
they should be adjusted, and how they interact with each other.
Table 3-3: Controls to Adjust the Radar Picture
Control Option Function Default Setting
GAIN GAIN
SEA
RAIN
FTC
Controls the strength of the target returns
Reduces sea returns
Reduces close rain or snow returns
Reduces distant rain or snow returns
AUTO
AUTO-HARBOUR
OFF
OFF
MULTI TUNE Fine tunes the receive AUTO
TARGETS
Soft Key
INT REJ
EXPANSION
WAKES
Turns interference rejection on/off
Turns target expansion on/off
Turns wakes on/off and selects wakes length
ON
OFF
OFF
81186_3.book Page 4 Thursday, August 22, 2002 8:23 AM