Filter
Top Products
9-2 hsb
2
PLUS Series LCD Display
Resetting the System
• In some installations, it maynot bepossible to prevent the equipment from
being affected by external influences. In general this will not damage the
equipmentbut it can lead tospurious resetting action, ormomentarily may
result in faulty operation.
9.2 Resetting the System
There are three types of reset available for the display:
• FactoryReset:Thisresets allvaluesbackto their originalfactorysettings.
CAUTION:
The factory reset clears the Marks database and the Waypoints and
Routes databases.
• Power-On Reset: When you turn the display off and on again, the screen
reverts to the chart or radar picture with all windows cleared.
• Picture Reset: Press and hold the DISPLAY key for two seconds to return
the screen to the full-screen picture of the top window with all windows
cleared.
At power-on, the last-used values are retained for all the options, except for
those listed in the following table which are reset to the factory default each
time.
➤ To perform a factory reset:
1. Press MENU.
2. Press the SYSTEM SET UP soft key to display the System Set Up page (see
Section 7.3 for details).
3. Press and hold MENU for 5 seconds.
A countdown timer is displayed. If you release the MENU key before the
timer reaches zero, the reset is not performed.
When the reset request has been accepted, the system restarts.
The factory default settings are listed in Section 7.3
Table 9-1: Power On Default Settings
Item Power-on setting
Heading Mode
Rain
FTC
Alarm
Zoom
Windows
Lighting & contrast )
Head Up
OFF (but value stored) – radar only
OFF (but value stored) – radar only
ON, with last-used value
OFF
OFF
Lighting 40%, contrast 50%
.
81186_3.book Page 2 Thursday, August 22, 2002 8:23 AM