Filter
Top Products
Chapter 8: Installation 8-19
Radar System Checks
and Adjustments
Display Timing Adjustment
The display timing can be affected by the length of the cable used to connect
the scanner to the display unit. This in turn affects the short range accuracy
shown on the display. If you have extended(or reduced) yourinter-unit cable,
you will need to check the display timing before using the system for
navigation.
Incorrect timing is most noticeable on the
1
/
8
nm or ¼ nm range scales. Targets
such as bridges or piers appear bent or bowed.
Note:Undernormalcircumstancesyoudo notneedtoadjustthesesettings,as
they are set automatically at the factory. If these parameters are set incor-
rectly the performance of the radar will be adversely affected. Access to this
menu is therefore via a hidden key press.
➤ To adjust for correct timing:
1. Select the
1
/
8
nm range.
2. Onthe radar locate a straight dock, seawall or bridge that is facing your
ship.Iftheimageisbentor bowed,asshowninthe followingdiagram,then
you need to adjust the timing.
Figure 8-10: Radar Display Timing
3. Press the MENU key to display the set up soft keys.
4. Press and hold the blank soft key directly to the right of the RADAR SET UP
soft key for 5 seconds. The Advanced Set Up menu is then displayed.
5. Usethe trackpad to move the selection bar down to the Display Timing
option.
6. Usethe soft keys to adjust the Display Timing slider. As soon as you start
the adjustment, the menu page is cleared so that you can see the effects of
the adjustment on the radar picture, and the radar is set to
1
/
8
nm range.
7. When the displayed image appears straight, press ENTER to return to the
Advanced Set Up soft keys.
8. Press CLEAR toreturn tothe set upsoft keys,and CLEAR againtoreturnto
the normal radar screen.
Alternatively, you can use a VRM in conjunction with a target at a known
distance and adjust the picture so the target co-incides with the VRM.
Own ship
Own ship
Timing early
Timing late
Normal
D4009-2
Own ship
81186_3.book Page 19 Thursday, August 22, 2002 8:23 AM