Filter
Top Products
Chapter 5: Standard Chart Operations 5-15
Using the ST60 or
ST80 Navigator
Keypad
CAUTION:
Takecare whenediting waypoints as itis possible to move waypointsthat
are used in routes stored in the Route Database. In such instances, the
stored route will include the waypoint in its new position.List.
➤ To move a waypoint using the cursor:
1. Movethecursorover thewaypoint,untilthe lettersWPT are displayed. The
waypoint soft keys are displayed.
2. Press MOVE WAYPOINT, the cursor changes to a four-headed arrow.
3. Movethe cursor to the required waypoint position.
Press ENTER to set the position and return to normal cursor control.
Press CLEAR to cancel the operation.
➤ To move a waypoint using the Waypoint Edit functions:
1. Selectthewaypointusingeitherthecursororthe waypointlistasdescribed
above. The waypoint soft keys are displayed.
2. To edit the waypoint position proceed as previously described in Editing
the Waypoint Details on page 5-13.
Using the ST60 or ST80 Navigator Keypad
If you have an ST60 or ST80 Navigator Keypad connected on SeaTalk it can
be used to name or edit your waypoints, tracks, or routes on any display in the
system.Thekeypadcanalsobe usedto selectentriesinthe WaypointList.The
Navigatorprovides10dedicatedalphanumerickeys,amultidirectionalcursor
control pad, plus Insert and Delete keys. The small red LED glows when the
keypad is operational.
Note: Whenusing the Navigator Keypad, youshould be awarethat itcan con-
trol several displays simultaneously; any display in edit mode (i.e. ready for
alpha-numeric data entry) will be affected by the Navigator Keypad.
Figure 5-5: ST80 Navigator Keypad
WPT
MOVE
WAYPOINT
D1934-2
2
def
3
ghi
1
abc
5
mn
6
opq
4
jkl
8
uvw
9
xyz
7
rst
0 del
ins
NAVIGATOR
81186_3.book Page 15 Thursday, August 22, 2002 8:23 AM