Filter
Top Products
10.29
ELECTRICAL
10
9923142 - 2011 RANGER RZR / RZR S / RZR 4 Service Manual
© Copyright 2010 Polaris Sales Inc.
Battery Conductance Analyzer
Conductance describes the ability of a battery to conduct
current. A conductance tester functions by sending a low
frequency AC signal through the battery and a portion of the
current response is captured, from this output a conductance
measurement is calculated. Conductance testing is more
accurate than voltage, specific gravity, or load testing.
Authorized Polaris dealers/distributors are required to use the
conductance analyzer when testing 12V Polaris batteries.
Charging Procedure
If battery voltage is 12.6 Vdc or less, the battery may need
recharging. When using an automatic charger, refer to the
charger manufacturer’s instructions for recharging.
Do not exceed 9 amps when charging the 4011496 battery.
Do not exceed 6 amps when charging the 4011224 battery.
NOTE: Charge the battery using an automatic
charger that will not exceed 14.6 Vdc. An automatic
charger will signal when charging is complete.
NOTE: Allow the battery to stand disconnected for
at least 1-2 hours after being properly charged. If the
voltage drops below 12.6 volts, charging was
ineffective or the battery needs to be replaced.
NOTE: Follow the charger instructions supplied by
the manufacture regarding the order or connections,
switch positions and when to connect the charger to
an outlet.
Polaris MDX-610P
SPX PN: PU-50296
WARNING
An overheated battery could explode, causing severe
injury or death. Always watch charging times carefully.
Stop charging if the battery becomes very warm to the
touch. Allow it to cool before resuming charging.
Battery PN 4011496
State of
Charge
Voltage (DC) Action
Charge
Time
100% 12.8 - 13.0
None, check
again in 3
months
None
Required
75% - 100% 12.5 - 12.8
May need
slight charge
3 - 6 hrs
50% - 75% 12.0 - 12.5 Needs Charge 5 - 11 hrs
25% - 50% 11.5 - 12.0 Needs Charge
At least
13 hrs
0% - 25% 11.5 or less Needs Charge
At least
20 hrs
Battery PN 4011224
State of
Charge
Voltage (DC) Action
Charge
Time
100% 12.8 or more
None, check
again in 3
months
None
Required
75% - 100% 12.6 - 12.8
May need
slight charge
3 - 6 hrs
50% - 75% 12.3 - 12.6 Needs Charge 5 - 11 hrs
25% - 50% 12.0 - 12.3 Needs Charge
At least
13 hrs
0% - 25% 12.0 or less Needs Charge
At least
20 hrs