Filter
Top Products
COMAND navigation (introduction)
95
You can use the favorite button to extend
or retract the rear window sunshade. This
is the default setting.
R
Display OFF (Y page 92)
You can use the favorite button to switch
the COMAND display on or off.
R
Repeat Navigation Command
(Y page 140)
You can use the favorite button to recall the
last announcement issued by the
navigation system.
X
Select Vehicle £ System Settings
£ Favorite.
The list of predefined functions appears.
The dot R in front of the list entry indicates
the current setting.
X
Changing setting: Rotate ymz and select
desired function.
X
Saving setting and exit the menu:
Press n.
Reset
i
You can reset COMAND back to its
factory settings.
In this case, all personal data (e.g. address
book entries, entries in the destination
memory and the list of last destinations of
the navigation system), among other
things, are deleted.
X
Select Vehicle £ System Settings
£ Reset.
A prompt appears asking whether you
really want to reset.
X
Select Yes or No.
If you select Yes another prompt will
appear asking whether you really want to
reset.
X
Select Yes or No.
If you select Yes, COMAND will be reset
and restarted.
COMAND navigation (introduction)
Safety notes
G
Warning!
For safety reasons, only enter a destination
when the vehicle is stationary. When the
vehicle is in motion, a passenger should
enter the destination. Study manual and
select route before driving.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.
COMAND calculates the route to the
destination without taking account of the
following, for example:
R
Traffic lights
R
Stop and right-of-way signs
R
Parking or stopping prohibited areas
R
Lane merging
R
Other road and traffic rules and
regulations
R
Narrow bridges
COMAND may give incorrect navigation
commands if the data in the digital map
does not correspond with the actual road/
Control systems
Z