Filter
Top Products
Driving systems
369
X
Switching off Parktronic system: Press
Parktronic switch 1.
Indicator lamp 2 comes on.
X
Switching on Parktronic system: Press
Parktronic switch 1 again.
Parktronic system malfunction
There is a malfunction in the Parktronic
system, if only the red distance segments
illuminate and an acoustic warning sounds.
The Parktronic system will switch off
automatically after 20 seconds and indicator
lamp 2 in Parktronic switch 1 comes on.
X
Have the Parktronic system checked at an
authorized Mercedes-Benz Center as soon
as possible.
If only the red distance segments illuminate
and no acoustic warning sounds, the
Parktronic system sensors are dirty (e.g. dirt,
ice, snow and slush) or there is an
interference from other radio or ultrasonic
signals (e.g. truck air brakes, car wash, or
jackhammers). The Parktronic system will
switch off automatically after 20 seconds and
indicator lamp 2 in Parktronic switch 1
comes on.
X
Switch off the ignition.
X
Clean the Parktronic system sensors
(Y page 465).
X
Switch on the ignition.
or
X
Check the Parktronic system operation at
another location to rule out interference
from outside radio or ultrasonic signals.
Park Assist
G
Warning!
The Park Assist is a supplemental system.
It is not intended to, nor does it replace, the
need for extreme care. The responsibility
during parking and other critical maneuvers
always remains with the driver.
G
Warning!
Make sure no persons or animals are in the
area in which you are maneuvering. You
could otherwise injure them.
!
Special attention must be paid to objects
with smooth surfaces or low silhouettes
(e.g. trailer couplings, painted posts,
elevated crossbars or road curbs). Such
objects may not be detected by the system
and can damage the vehicle.
i
USA only:
This device has been approved by the FCC
as a “Vehicular Radar System”. The radar
sensor is intended for use in an automotive
radar system only. Removal, tampering, or
altering of the device will void any
warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use in
any non-approved way.
Any unauthorized modification to this
device could void the user’s authority to
operate the equipment.
i
Canada only:
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions:
1. This device may not cause interference,
and
2. this device must accept any
interference received, including
interference that may cause undesired
operation of the device.
Removal, tampering, or altering of the
device will void any warranties, and is not
Controls in detail
Z