Filter
Top Products
COMAND satellite radio
192
X
Select category by rotating ymz or sliding
qmr and press n.
When selecting a channel using the
channel search function or the channel list,
you have access to the channels you
subscribe to and which are included in the
selected category.
i
When you select the category All
Channels, you have access to all the
channels you subscribe to, regardless of
category, when you are tuning in a channel
using the channel search function or the
channel list.
Tuning in channels
You have the following selection options:
R
The channel search function
R
The channel presets
R
The manual channel number entry
R
The channel list
Tuning in channels using channel
search function
i
If you try to tune in a channel when the
satellite radio service is not activated, you
will see the screen described in the section
“Satellite radio service is not
activated” (Y page 190).
X
Slide omp or rotate ymz when the main
area is selected.
Depending on the direction in which the
controller is being pressed or rotated, the
system searches upward or downward and
stops at the next receivable channel.
i
Which channels are found by the channel
search function depends on which
channels you have subscribed to and the
program category you have selected
(Y page 191).
Tuning in channels using channel
presets
X
Select Audio £ Audio £ Sat Radio
£ Presets.
or
X
Press n when the main area is selected.
The preset menu appears. The dot R in
front of a preset position indicates that this
is the channel currently selected and being
listened to.
X
Select station preset and briefly press n.
or
X
Enter a position number with the telephone
keypad using the A - 9 buttons
(Y page 81).
COMAND tunes in the corresponding
channel as long as it is included in your
subscription and is still available.
If the channel is not included in your
subscription, you will see the message
described in the section “Satellite radio
service is not activated” (Y page 190).
If the channel is no longer available, you will
see the message Invalid Channel.
X
Closing message: Press n.
Control systems