Filter
Top Products
COMAND navigation system (route guidance)
140
Off-road during route guidance
The road layout may differ from the data on
the digital map, due to road construction
measures, for example.
In such cases, the system cannot allocate the
vehicle position to the digital map and the
vehicle is therefore in an off-road position.
The Off Road message and an arrow showing
the compass heading to the destination
appear on the display.
As soon as the system can allocate the
vehicle position to the map again, route
guidance continues in the usual way.
Navigation announcements
G
Warning!
Navigation announcements are intended to
direct you while driving without diverting
your attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your
risk of an accident.
i
If Russian or Chinese is set as the system
language, the navigation announcements
are in English. You will find how to set the
system language on (Y page 94).
Navigation announcements are muted
during telephone calls. You can, however,
call up a current announcement at any
time. You can also call up a current
announcement at any time if you have
missed an announcement.
Route guidance is already active.
X
Calling up a current announcement:
Select Navi £ RPT.
or
X
Press P favorite button if the button has
been programmed with this function
(Y page 94).
X
Switching off navigation messages:
Press F during an announcement.
You will see the message The driving
instructions have been muted. for a
short while.
i
The announcements remain switched off
even if you start a new route guidance or if
COMAND is switched off/on with the
o button.
If you switch COMAND off by removing the
SmartKey from the starter switch and then
switch the ignition back on after more than
3 minutes, the announcements are
automatically switched back on.
X
Switching navigation announcements
back on manually: Select Navi £ RPT.
X
Adjusting volume of the messages:
Adjust the volume during an automatic
announcement (Y page 88).
or
X
Call up an announcement manually using
Navi £ RPT and adjust the volume
(Y page 88).
Control systems