Filter
Top Products
Voice Control navigation
256
or
R
“Navigate <voice name> work”
to directly select between home or work
address for that name. The system
confirms your selection, calculates the
route, and begins route guidance.
Sample dialog:
s
Navigate to John Smith
If more than one address exists for this
voice entry, the Voice Control System
will prompt you:
t
Navigate to home or work?
s
Work
t
John Smith work
Starting route guidance
“Start route guidance”
Use the command “Start route guidance” to
start route guidance after entering a valid
destination.
Sample dialog:
s
Start route guidance
t
Starting route guidance
Route guidance begins.
“Guidance instructions on”
Use the command “Guidance instructions on”
to have the Voice Control System repeat the
last guidance instruction. If guidance voice
output was previously muted, using this
command will deactivate the muting of the
voice output.
“Guidance instructions off”
Use the command “Guidance instructions
off” to mute the system’s guidance voice
output.
“Cancel route guidance”
Use the command “Cancel route guidance”
to cancel route guidance.
Sample dialog:
s
Cancel route guidance
t
Are you sure you want to cancel route
guidance?
s
Yes
Route guidance is canceled.
or
s
No
t
Cancel
The dialog with the Voice Control System is
canceled. Route guidance remains active.
“Map”
Use the command “Map” to activate or switch
to map display.
“Zoom in”, “Zoom out”
Use these commands to zoom in on map or
to zoom out of map to the desired level of map
detail.
“Zoom in completely”, “Zoom out
completely”
These commands are used to adapt the map
display directly to the smallest or largest map
scale.
“List destination memory”
Use the command “List destination memory”
to have the system read out all destination
memory entries and select and entry for route
guidance.
Sample dialog:
s
List destination memory
Control systems