Filter
Top Products
COMAND navigation system (entering a destination)
122
X
In the address input menu, select
Intersection.
The list of intersections appears either with
or without the input characters
(Y page 123). Whether or not the input
characters appear depends on how many
intersections are available for the selected
street.
List of intersections with input characters
When this list appears, the input characters
4 are automatically activated.
1
Top list entry based on the input data up
to that point
2
Characters entered by the user
3
Characters automatically added by the
system
4
Input characters
5
Currently non-selectable characters
6
Currently selectable character
7
List of intersections
8
Currently selected character
i
In the list of input characters 4, you can
only select currently selectable characters.
Which characters are included depends on
the sequence in which you have entered
your destination and the data version of the
digital map.
While the characters are being selected as
described below, the top list entry 1 always
shows the intersection which best
corresponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with appropriate characters 3.
X
Selecting characters: Slide omp or
rotate ymz.
X
Confirming character selection:
Press n.
X
Deleting individual characters:
Select ) in the bottom line and press n.
X
Deleting an entire entry: Select ) in the
bottom line and press n until the entire
entry is deleted.
X
Canceling character entry: Select Back
in the bottom line and press n.
or
X
Press back button L in the center
console (Y page 86).
As soon as COMAND can clearly attribute the
characters entered to an intersection, the
input characters 4 disappear. You see the
list of intersections without the input
characters. Here you can confirm the current
entry or make another selection.
During character entry, you can also manually
switch to the list of intersections without
input characters at any time.
X
Switching manually to the list of
intersections without input
characters: Slide qm.
or
X
Select d in the second line from the
bottom and press n.
Control systems