Filter
Top Products
COMAND navigation system (entering a destination)
126
Entering a destination from the list of
last destinations
X
Select Navi £ Destination £ From
Last Destinations.
The list of last destinations appears. The
most recent destination is at the top of the
list.
X
Select desired destination.
X
Starting route calculation: Select
Start, see also (Y page 123).
Entering a destination from the map
i
Depending on the factory settings of the
vehicle, it may not be possible to enter a
destination while the vehicle exceeds a
preset speed. As soon as the vehicles
speed drops to below the preset speed, the
function is available again. You can enter a
destination via the map if the digital map
does not contain the address of the
destination, but the destination must be
within the area of the digital map.
Calling up the map
X
In the address input menu, select Map
(Y page 108).
You will see the map with a cross hair. The
map is set to the address set in the address
input menu.
or
X
Select Navi £ Destination £ Via
Map.
You will see the map with a cross hair.
1
Cross hair
2
Details of the cross hair position
3
Map scale
i
Display 2 may be the name of a road, for
example, provided the digital map contains
the necessary data.
If no data is available, display 2 shows:
R
the coordinates if the geocoordinate
display is switched on (Y page 106)
R
no display if the geocoordinate display is
switched off (Y page 106)
Moving the map and selecting the
destination
X
Moving map: Slide qmr, omp or wmx.
X
Adjusting map scale: Rotate ymz.
Rotating clockwise enlarges the map,
rotating counterclockwise reduces it.
X
Selecting a destination: Press n.
If the cross hair is located off the edge of
the digital map, a route cannot be
calculated to this destination and you will
see the message The destination is
located off the map..
X
Select OK.
X
Move the map and select a destination
again.
If the destination is within the limits of the
digital map, COMAND attempts to attribute
the destination to the map, which can take
approximately 2 seconds.
If the destination can be attributed, you will
see the address of the destination. If not,
Control systems