Filter
Top Products
COMAND introduction
88
X
Confirming selection: Press n.
The selected station is saved at the
designated position. The display switches
back to the Radio display.
Main menus of COMAND
i
The components and operating principles
of COMAND can be found on (Y page 78).
Sound
X
Muting: Press shortcut button F in the
center console (Y page 79).
The sound of the current audio source is
switched on or is muted.
i
When the sound is muted, you will see the
symbol F in the status line. When you
change the audio source, the sound is
automatically switched on. You will be able
to hear announcements from the
navigation system even when the sound is
muted.
Switching off navigation announcements
entirely
X
Canceling navigation message: Briefly
press shortcut button F during an
announcement.
X
Switching off navigation messages:
Press and hold F during an
announcement until the announcement is
switched off.
You will see the message The driving
instructions have been muted. for a
short while.
i
The announcements remain switched off
even if you start a new route guidance or if
COMAND is switched off/on with the
o button. If you switch COMAND off by
removing the SmartKey from the starter
switch and then switch the ignition back on
after more than 3 minutes, the
announcements are automatically
switched back on.
Adjusting volume
1
Thumbwheel
X
Adjusting: Turn thumbwheel ,.
The volume of the currently selected audio
source changes.
Volume of navigation announcements
You can adjust the volume of the navigation
announcements independently from the
volume of the respective audio source.
During a navigation announcement:
X
Turn thumbwheel ,.
or
X
Press æ or ç on the multifunction
steering wheel.
Control systems