Filter
Top Products
COMAND navigation system (entering a destination)
118
While the characters are being selected as
described below, top list entry 1 always
shows the center which best corresponds to
the input data as it has been entered up to
that point. At the same time, COMAND
automatically supplements characters 2
entered by the user with appropriate
characters 3.
X
Selecting characters: Slide omp or
rotate ymz.
X
Confirming character selection:
Press n.
X
Deleting individual characters:
Select ) in the bottom line and press n.
X
Deleting an entire entry: Select ) in the
bottom line and press n until the entire
entry is deleted.
X
Canceling an entry: Select Back in the
bottom line and press n.
or
X
Press back button L in the center
console (Y page 86).
As soon as COMAND can clearly attribute the
characters entered to a center, input
characters 7 disappear. You see the list of
centers without the input characters. Here
you can confirm the current entry or make
another selection.
During character entry, you can also manually
switch to the list of centers without input
characters at any time.
X
Switching manually to the list of
centers without input characters: Slide
qm.
or
X
Select d in the second line from the
bottom and press n.
List of centers without input characters
X
Selecting a center: Slide qmr or rotate
ymz.
X
Canceling selection: Select Back and
press n.
or
X
Press back button L in the center
console (Y page 86).
X
Confirming selection: Press n.
After the confirmation, the address input
menu appears again. It shows the center,
city and state (USA) or province (Canada).
Which of the following menu items are now
available may depend on the data version
of the digital map. The menu items which
are not available cannot be selected.
R
Map: Using the map to enter a destination
(Y page 126)
i
In this case, using the map for destination
entry is based on the center seen in the
address input menu.
R
POI: Entering a point of interest
(Y page 128)
i
In this case, entering a point of interest is
based on the center seen in the address
input menu.
Control systems