Filter
Top Products
COMAND navigation system (entering a destination)
109
List of states with input characters
1
Top list entry based on the input data up
to that point
2
Characters entered by the user
3
Characters automatically added by the
system
4
Clear last character entry
5
Currently selectable characters
6
Currently non-selectable characters
7
Input characters
8
List of states
9
Currently selected characters
i
In the list of input characters 7, you can
only select currently selectable characters.
Which characters are included depends on
the sequence in which you have entered
your destination and the data version of the
digital map.
While the numbers are being selected as
described below, the top list entry 1 always
shows the state which best corresponds to
the input data as it has been entered up to
that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with other likely input characters 3.
X
Selecting characters: Slide omp or
rotate ymz.
X
Confirming character selection:
Press n.
X
Deleting individual characters:
Select ) in the bottom line and press n.
X
Deleting an entire entry: Select ) in the
bottom line and press n until the entire
entry is deleted.
X
Canceling an entry: Select Back in the
bottom line and press n.
or
X
Press back button L in the center
console (Y page 86).
As soon as COMAND can clearly attribute the
characters entered to a state, the input
characters 7 disappear automatically. You
see the list of states without the input
characters. Here you can confirm the current
entry or make another selection.
During character entry, you can also manually
switch to the list of states without input
characters at any time.
X
Switching manually to list of states
without input characters: Slide qm.
or
X
Select d in the second line from the
bottom and press n.
List of states without input characters
Control systems
Z