Filter
Top Products
COMAND navigation (introduction)
106
Arrival time and distance
You can set whether the estimated arrival
time and the distance to the destination
should be displayed in the map.
X
Displaying: Select Navi £ Navi £ Map
Display.
The map display list appears. A dot R
indicates the current setting.
X
Select Arrival Time/Distance.
Depending on the previous status the
display showing the arrival time and
distance is switched on or off.
Current street
You can set whether the current street you
are driving on should be displayed in the map.
X
Displaying: Select Navi £ Navi £ Map
Display.
The map display list appears. A dot R
indicates the current setting.
X
Select Current Street.
Depending on the previous status the
display showing the current street is
switched on or off.
Geocoordinate display
Example illustration: Map with geocoordinate
display switched on
1
Current height above sea level
2
Number of GPS satellites from which
signals for positioning can be received
3
Coordinate display
i
There must be sufficient GPS reception
for displays 1, 2 and 3 to be shown.
Height display 1 is an approximation
because the navigation system uses the
GPS signals for the calculation.
Display options with geocoordinate
display switched on
If the cross hair is displayed on the map view
(map was moved manually), only display 3
is visible.
It shows either the coordinates of the cross
hair or other data on the cross hair position,
e. g. a street name. The digital map must
contain relevant data in order for this other
data to be displayed.
i
If there is no cross hair on the map view,
displays 1, 2 and 3 are visible. Display
3 shows the coordinates of the current
vehicle position.
Switching the geocoordinate display on or
off
X
Select Navi £ Navi £ Map Display.
The map display list appears.
X
Select Coordinates.
The geocoordinate display is switched on
or off, depending on the previous status. A
checkmark indicates which status is active.
X
Exiting menu: Slide omp or press back
button L in the center console
(Y page 86).
Setting route type
You can set the following route types:
R
Fast Route: COMAND calculates a route
with the shortest possible (minimized)
driving time.
R
Short Route: COMAND calculates a route
with the shortest possible (minimized)
Control systems