Filter
Top Products
Voice Control telephone
262
or, with longer phone numbers,
R
in digit blocks (three to five digits in each
block).
After each digit block (separate the digit
blocks by using an approximately 0.5 second
pause), the Voice Control System repeats the
recognized digits and waits until you continue
speaking.
After the command “OK”, you will be
prompted up to two times to input the name.
When repeating the name, make sure that you
pronounce it in the same manner as during
the first input. Otherwise the name cannot be
saved and the Voice Control System cancels
the save procedure.
i
The Voice Control System may recognize
names even if not saved in your voice. For
optimum call-up performance, however,
you should speak and save the names you
intend to use yourself.
i
You can also add a name to an entry by
calling up the corresponding menu on
COMAND and saying the name twice
(Y page 178).
Sample dialog:
s
Save name
t
Please say the number first
s
One two three
t
One two three
s
Four five six seven
t
Four five six seven
s
OK
t
Please say the name
s
John Smith
t
Please repeat the name
s
John Smith
t
Do you want to save the number in a
category?
s
No
t
Name and number saved
“Dial name” (COMAND address book)
Use the command “Dial name” to place a
phone call by selecting a name previously
saved in your personal address book.
Sample dialog:
s
Dial name
t
Please say the name
s
John Smith
If several telephone numbers exist for
the same entry, the Voice Control
System will ask for clarification.
t
Do you want to place a work call or a
home call?
s
Work
t
John Smith work
Dialing
“Call <voice entry>” (address book)
Use the command “Call <voice entry>” to
place a phone call by directly selecting a
name previously stored in your address book.
One address book entry can have up to three
different telephone numbers (mobile phone/
car/land line) for both the home and work
fields.
If only one telephone number is stored for a
given name, you can recall the entry using the
command “Call John Smith”.
If several telephone numbers are associated
with one entry, you can recall the desired
telephone number by using the following
commands:
R
“Call John Smith home”
R
“Call John Smith work”
R
“Call John Smith home cell phone”
Control systems