Filter
Top Products
Voice Control navigation
255
s
Yes
t
Starting route guidance
i
Depending on the number of categories
and POI’s available for a given area, the
system may display several lists on each of
which you may have to make a selection by
speaking the desired line number or you
have to spell the name of a POI.
“Next POI”
With the commands
R
“Next gas station”
R
“Next parking lot”
R
“Next Mercedes-Benz service”
R
“Next restaurant”
R
“Next hospital”
you can select POIs in your vicinity.
Sample dialog:
s
Next gas station
u
The system shows a numbered list of
gas stations on the COMAND display
t
Please select a line number
s
Number one
t
Number one accepted
t
Do you want to start route guidance?
s
Yes
The system calculates the route and, upon
completing route calculation, starts route
guidance.
“Last destinations”
Use the command “Last destinations” to
select a destination from among a number of
destinations last navigated to.
“Save destination”
Use the command “Save destination” to save
the current destination in the address book.
i
The Voice Control System may recognize
names even if not saved in your voice. For
best possible call-up performance,
however, you should speak and save the
names you intend to use yourself.
If an entry is already available in the
address book, the system will ask you if you
would like to add the address to the
available entry.
Sample dialog:
s
Save destination
t
Please say the name
s
John Smith
t
Please repeat the name
s
John Smith
t
Where do you want to save: home or
work?
s
Work
t
The destination has been saved
“Navigate to <voice entry>” (address
book)
Use the command “Navigate to <voice
entry>” to start route guidance by selecting
voice entry with a saved destination address
from the COMAND address book.
A voice entry may have two different
destination addresses associated with it
(home or work).
The system confirms your command,
calculates the route, and begins route
guidance. If only one address is stored, you
can use the command “Navigate <voice
name>” to select the stored destination
address for that name.
If two addresses are stored, you can use the
commands
R
“Navigate <voice name> home”
Control systems
Z