Filter
Top Products
COMAND navigation system (entering a destination)
125
While the characters are being selected as
described below, the top list entry 1 always
shows the destination which best
corresponds to the input data as it has been
entered up to that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with appropriate characters 3.
X
Changing language for the input
characters: Select !.
X
Select desired language.
X
Changing character set for the input
characters: Select #.
Depending on the previous setting, you will
change to letters with special characters or
to numbers with special characters.
X
Selecting characters: Slide omp or
rotate ymz.
X
Confirming character selection:
Press n.
X
Deleting individual characters:
Select ) in the bottom line and press n.
X
Deleting an entire entry: Select ) in the
bottom line and press n until the entire
entry is deleted.
X
Canceling an entry: Select Back in the
bottom line and press n.
or
X
Press back button L in the center
console (Y page 86).
As soon as COMAND can clearly attribute the
characters entered to a destination, the input
characters 4 disappear. You see the
destination memory list without input
characters. Here you can confirm the current
entry or make another selection.
You can also manually switch to the
destination memory list without input
characters at any time.
X
Switching manually to the destination
memory list without input characters:
Slide qm.
or
X
Select d in the second line from the
bottom and press n.
Destination memory list without input
characters
X
Selecting a destination: Slide qmr or
rotate ymz.
X
Canceling selection: Press back button
L in the center console (Y page 86).
or
X
Select Back and press n.
i
The Back menu item is only present if this
list was called up from the list with input
characters.
X
Confirming selection: Press n.
X
Starting route calculation: Select
Start, see also (Y page 123).
Control systems
Z