Filter
Top Products
COMAND navigation system (route guidance)
137
Example of a display without driving
maneuvers
1
Main destination <
2
Stopover = (only visible if a stopover has
been entered)
3
Route (highlighted blue)
4
Current vehicle position; the triangle
indicates the vehicle’s direction of travel
5
Set map orientation – for an explanation
and settings, see (Y page 105)
6
Set scale – for an explanation and
settings, see (Y page 103)
Destination or destination area
reached
Once you have reached your destination, you
will hear the announcement You have
reached the destination. For certain
POIs (airports or highway junctions), you will
hear the announcement You have reached
the destination area. In addition, you will
see a corresponding display and route
guidance is automatically ended.
1
Destination on the map
2
Destination flag
Partially digitized areas
i
The digital map may contain areas that
are only partially digitized although they are
within a digitized region.
G
Warning!
Due to incomplete digitization, the route
shown on the map may differ from the
actual road/traffic situation.
If you follow the route shown on the map,
for example, it is possible that you could
drive the wrong way down a one-way street
or that a street cannot be driven on.
When using route guidance in a partially
digitized area, you must therefore be sure
to observe all relevant traffic regulations
and the course of the road.
All relevant traffic regulations and the
course of the road always take priority over
the route shown on the map.
If the destination is within a partially
digitized area
COMAND guides you through fully digitized
areas for as long as possible. Route guidance
is conducted in the usual manner, i. e. with
navigation announcements and route
guidance displays.
Control systems
Z