Filter
Top Products
REFERENCE
The ‘Auto Track’ setting
allows the simulator to
automatically “line up” on
the correct bearing to a des-
tination waypoint. ‘User
Track’ allows you to set the
ground track to any direc-
tion.
Alarms are provided for
various airspace categories,
arrival, CDI and an alarm
clock. To set the alarm
clock, enter the time when
you wish the alarm to
sound.
66
SIMULATOR SETTINGS
The simulator submenu provides complete setup control of the
simulator mode. From this page, you may designate a starting posi-
tion and altitude, enter a simulated speed and define a ground track.
To turn the simulator mode on or off:
1. Highlight the ‘Mode’ field and press
T
.
2. Select ‘Simulator On’ or ‘Simulator Off’ and press
T
.
To designate the simulated position and altitude:
1. Highlight the ‘Position’ field and press
T
.
2. Enter the latitude/longitude coordinates for the starting position and
press
T
.
3. The highlight will move to the ‘Altitude’ field. Press
T
.
4. Enter the starting altitude and press
T
.
To set the simulated track and speed:
1. Highlight the ‘Track Control’ field and press
T
.
2. Select ‘Auto Track’ or ‘User Track’ and press
T
. If ‘User Track’ is
selected press
T
, enter the desired ground track and press
T
again. ‘Auto Trac’ will automatically adjust the ground track based
upon the bearing to an active GOTO or route waypoint.
3. Highlight the ‘Speed’ field and press
T
.
4. Enter the desired speed and press
T
.
An options menu allows you to designate the simulated position
using the map display, instead of entering position coordinates.
To designate the simulated position from the map display:
1. Press
O
followed by
T
to select ‘Initialize Position?’.
2. Select the starting location using the
R
keypad (and
A
if nec-
essary) and press
T
when finished.
The alarms submenu provides controls for the alarm clock,
arrival alarm, course deviation alarm and the various airspace alerts.
The alarm clock uses the internal clock to provide an ‘Alarm Clock’
message at the time you set.
To enable/disable the alarm clock:
1. Highlight the ‘Clock Alarm’ field and press
T
.
2. Select ‘On’ or ‘Off’ as desired and press
T
.
3. If enabling the alarm, highlight the time field and press
T
. Enter
the alarm time and press
T
. When the alarm time is reached the
GPSMAP 195 will alert you with the ‘Alarm Clock’ message. (The
GPSMAP 195 must be powered on when the alarm time is reached.
Otherwise, the message will not occur.)
ALARMS SETTINGS
Main Menu: Setup
gps 195 manual C 7/1/99 4:49 PM Page 66