Filter
Top Products
APPENDIX D
101
MESSAGES (cont.)
RAM has Failed—The GPSMAP 195 has detected a
failure in its internal memory. If the message persists,
the GPSMAP 195 is unusable and should be taken to
an authorized GARMIN service center.
Received an Invalid Waypoint—A waypoint was
received during upload transfer that has an invalid
identifier.
Receiver has Failed—A failure in receiver hardware
has been detected. If this message persists, do not use
the unit and take it to an authorized dealer for repair.
ROM has Failed—The GPSMAP 195 has detected a
failure in its permanent memory. If this message
occurs, the unit is unusable and should be taken to an
authorized GARMIN service center.
Route is Full—You have attempted to add more than
30 waypoints to a route.
Route Memory is Full—Route memory is full and no
additional routes can be added from another GPSMAP
or using the PC software kit.
Route Truncated—The route was truncated because
not enough room existed to insert an approach.
Waypoints are removed from the beginning of the
route to make room for the approach waypoints.
Route Waypoint Locked—The waypoint was locked
when the database was updated, since the waypoint
does not exist in the new database.
Route Waypoint Moved—The waypoint was moved
when the database was updated, due to a change in the
position information in the database.
Route Waypoint was Deleted—A route waypoint
entered does not exist in the database and has been
deleted from the route.
RTCM Input has Failed—DGPS data being received
has been lost. You are no longer receiving the beacon
signal.
Searching the Sky—The GPSMAP 195 is in search-
ing the sky for almanac data or the unit is in
AutoLocate mode.
Steep Turn Ahead—This message appears approxi-
mately one minute prior to a turn that requires a bank
angle in excess of 25 degrees in order to stay on
course.
Stored Data was Lost—All waypoints, routes, time
and almanac data has been lost due to battery failure
or clearing the receiver’s memory.
There is No RTCM Input—The GPSMAP 195 is
extracting DGPS corrections using an RTCM format.
No corrections are being received.
Timer Has Expired—The countdown timer has
expired.
Track Memory Is Full—Track log memory is full. No
additional track log data can be stored without delet-
ing old data to fill memory space.
Transfer has been Completed—The receiver is fin-
ished uploading or downloading information to the
connected device.
Vertical Nav Cancelled—The VNAV function has
been cancelled due to a change in the active route.
VNAV Needs MSL Target Altitude—The VNAV
function was implemented for a user waypoint or a
database waypoint without an altitude reference.
Select an MSL target altitude to use the VNAV feature
with this waypoint.
Waypoint Already Exists—You have entered a way-
point name on the AutoStore page or user waypoint
page that already exists in memory. Enter a waypoint
name that does not exist.
Waypoint Memory is Full—You have used all 250
waypoints in the GPSMAP 195. Delete unwanted way-
points to make room for new entries.
gps 195 manual C 7/1/99 4:49 PM Page 101