Filter
Top Products
REFERENCE
Select from 2, 4, 6, or 8
data fields plus compass or
CDI. As you add more data
fields the area covered by
the map display becomes
smaller.
From the ‘Change Data
Fields?’ option, a list of
available data options is
displayed.
55
MAP PAGE OPTIONS (cont.)
• Number of Data Fields?— allows you to specify the num-
ber of fields displayed in the data window section of the map
page. A graphic track compass or CDI scale may also be dis-
played. The following options are available:
• 2 Fields • 2 Fields & Compass
• 2 Fields & CDI • 4 Fields
• 4 Fields & Compass • 4 Fields & CDI
• 6 Fields • 6 Fields & Compass
• 6 Fields & CDI • 8 Fields
To change the number of data fields:
1. Highlight the ‘Number of Data Fields?’ option and press
T
.
2. Select the desired option and press
T
.
• Change Data Fields?— allows you to specify the data
displayed in each data field at the top of the map
page. Definitions for unfamiliar terms may be found in
Appendix F. The following options are available:
• BRG- bearing to active (destination) waypoint
• CTS- course to steer
• DIS- distance to active (destination) waypoint
• DTK- desired track
• ETE- estimated time enroute
• ETV- estimated time to VNAV
• GR- glide ratio
• GRT- glide ratio to target
• SPD- ground speed
• TRK- ground track
• TRN- turn angle to waypoint
• VST- vertical speed to target
• WPT- active (destination) waypoint name
• XTK- crosstrack error
To change a data field:
1. Highlight the ‘Change Data Fields?’ option and press
T
.
2. Highlight the data field you wish to change and press
T
.
3. Select the desired data field option and press
T
.
4. Press
Q
to remove the on-screen cursor.
• Setup Map Features?— allows you to configure the map
display to your preferences, including the map
orientation, automatic zoom, track and route detail, and
character fonts.
Map Page
gps 195 manual C 7/1/99 4:49 PM Page 55