Filter
Top Products
cGPSmapper Manual Map Project
http://cgpsmapper.com/ 23 of 100
Routeparam=xxx
NodID#=xxx
[END]
Section terminator.
4.2.4.4 Point of Interest from OziExplorer
[WPT]
Point of interest section identifier, with data imported from
an OziExplorer .wpt file.
The object labels are derived from the waypoint description
field, not from the waypoint name field
RgnType=object_cat
egory
0x10 POI
0x20 point
Type=object_type
Refer to section 4.2.4.1 (on page 18) for details.
EndLevel=#
Refer to section 4.2.4.1 (on page 18) for details.
File#=file_name
.wpt file from which data will be imported to layer #.
The path could be either
absolute or
relative to the current directory.
For platform portability, it is recommended to use slashes "/"
instead of backslashes "\" to separate directories in the path.
In Unix, file_name is case sensitive.
[END]
Section terminator.
4.2.4.5 Polyline or Polygon from OziExplorer
[PLT]
Polygon / Polyline section identifier, with data imported
from an OziExplorer .plt file.
RgnType=object_cat
egory
0x40 polyline
0x80 polygon
Type=object_type
Refer to section 4.2.4.1 (on page 18) for details.
Label=object_name
Refer to section 4.2.4.1 (on page 18) for details.
If the track imported in the [PLT] section contains multiple
segments (i.e. objects), all segments will take the same label
(name), as defined by the Label statement. However, it is
possible to give a different name to each segment. To
achieve this, omit the Label statement and specify the names
in an additional file, which should have the same name as the
.plt file (including the extension) and the additional
extension .txt, e.g. Highways.plt.txt). The file must be in the
same directory as the .plt file. Each line in this file specifies
the name for the corresponding track segment.
DirIndicator=#
Direction indicator, only for streets, highways, etc.
0 no direction
1 the GPS will show direction of the road (calculated
internally by GPS)
Default = 0
EndLevel=#
Refer to section 4.2.4.1 (on page 18) for details.